Precision Control Systems PanelIR 4555 - Manual (Page 14)

Model 4555 PanelIR TM User Manual Installation
MECHANICAL
INSTALLATION
Figure 3-1 Typical
installation
drawing for
model 4555
heater.
Installation
Tools Required:
• Phillips Screwdriver
• Slotted Screwdriver
• Hammer
• Metal Punch
• Pliers
• Tape Measure
• Tin snips/Metal cutting scissors.
As shown in Figure 3-1, four ¼-20 screws are provided on the top of the Model 4555
heater for mounting purposes. The heater can be attached directly to a suitable frame
structure or mounting brackets using these four screws. The distance between the heater
and target should be determined before mounting the heater. The heater should be
mounted so that each end cover may easily be removed for lamp installation.
Multiple Model 4555 heaters can be mounted side-by-side to form large heating arrays.
Screws (4X)
1/4 - 20
Mounting
Frame
Target
CAUTION!
Heater to
Target Distance
The back and end covers of Model 4555 heaters should not be exposed to
temperatures exceeding 425°F (218°C). The heater should not be
surrounded or enclosed by any type of insulating material.
Research, Inc. 11