Pyromation Series 423 - Manual (Page 6)

Page 5
5-1 UNPACKING
Pyro
MATION, INC.
s
t
l
1.89"
3.78"
1
C
F
2
Figure 1
Pyro
MATION, INC.
s
t
l
3.78"
1
C
F
2
Pyro
MATION, INC.
3.78"
Figure 3
3.56" MIN.
3.67" MIN.
Figure 4
Figure 2
1.77"
MIN.
5-4 MOUNTING ILLUSTRATIONS
5.58"
0.0 - .188" THICK
.25"
Unpack the instrument immediately upon receipt, and visually
inspect for shipping damages. If the instrument was damaged in
transit, note any damage and file a claim with the carrier.
Figure 1 thru figure 4 below shows panel cutout dimensions and
case dimensions. (For units with 12 position selector, cutout dimensions are
3.67" high by 3.56" wide). Remove slide retaining screws and slides.
Insert the instrument through the cutout from the front side of the panel
and re-insert slides and screws. Do not over-tighten screws.
5-3 MOUNTING
5-2 LOCATION
Install the instrument in an area where it will not be subjected to
excessive shock, vibration, dirt, oil, and where the temperature will not
exceed 0-50°C (32-122°F). The instrument should not be installed in
an area where rapid temperature changes may occur
(e.g. near heating
or cooling ducts).