Revo R16DVR4 - Manual (Page 28)

User’s Manual
22
NOTE: The video signal has a time difference of 1/60 second (1/50 second for PAL) between odd and even
fields because it is composed of 60 interlaced fields per second (50 fields for PAL). When recording video
with Very High (D1) resolution, video is made up of frame units combining two fields – one odd field and one
even field. This can cause horizontal scan lines or flashes in areas with motion because of the time difference
between the two fields. Turning on the de-interlace filter provides clearer video by eliminating these horizontal
scan lines and flashes.
 Record Audio: Selecting the box records audio from up to eight inputs when video is recording.
 Auto Deletion: Adjust the length of time recorded data will be kept by using the slide bar or Up and Down arrows
buttons. Selecting Never will disable the Auto Deletion function. The DVR automatically deletes video recorded
earlier than the user-defined period under three conditions: at midnight, whenever the system reboots or whenever
the user changes the Auto Deletion settings.
Panic Record Settings (RECORD  Panic Record Tab)
 Use Panic Recording: Check the box when using the
Panic recoding function.
 Panic Recording Duration: Set the duration of panic
recording. Panic recording will stop automatically after the
preset duration as long as the PANIC button on the remote
control is not pressed to stop the panic recording.
 Panic Recording ips: Set the images per second for Panic
recording.
 Panic Recording Quality: Set the recorded image quality
for Panic recording.
 Panic Recording Resolution: Set the recorded image
resolution for Panic recording.
Schedule Settings (RECORD
 Schedule Tab)
The DVR provides two recording schedule modes: Basic and Advanced. The Basic schedule mode allows you to set
recording settings for all camera channels at one time. The Advanced schedule mode allows you to set recording settings
for each camera channel.
Setting up the Basic Schedule Mode…
 Schedule Type: Select the Basic schedule mode.
 Record Schedule: Select the time range that the scheduled
recording will take place.
 Mode: Select the desired recording mode. ( : Time (Time-
lapse) recording, yellow : Pre-Event recording, red :
Post-Event recording, & red : Time & Post-Event
recording, yellow & red : Pre-Event recording & Post-
Event recording)
 ips: Set the images per second for the selected recoding
mode.
 Quality: Set the recorded image quality for the selected
recoding mode.
 Resolution: Set the recorded image resolution for the selected recoding mode.
 Dwell: Set the length of time you would like to record for the selected recoding mode.