Revo RECDH409-2 - Manual (Page 8)

4
2.
Push the liner on the sides where the patterns are put in the teeth of a comb
and pull it out.
To remove dome cover, turn the dome body counterclockwise until locators
reach end of travel and pull off.
Screw Tapping (M6)
Drilling Guide Label
Plastic anchor
Dr
l in
osi
tion
(P
A5
)
i l
g P
3. Attach the housing to the ceiling using suitable fasteners, M6x35 tapping
screws are supplied only use if they are suitable.
Turn the housing to right direction about 16 degrees to lock in place.
4. The assembly of the dome body and liner is in reverse order of disassembly.
Finally, lock dome body with locking screw(M3X5) from the accessory kit.
CEILING / WALL