Revo REVDN700E-2 - Manual (Page 18)

recording start.
*) In Simple mode is not supported.
In & Out
Direction
Rect Detect object moving. From top to enter of
area, detecting direction of moving out.
*) Please don’t use as a signal for video
recording start.
*) In Simple mode is not supported.
In & Out
Direction Rect Detect object moving. From right to enter of
area, detecting direction of moving out.
*) Please don’t use as a signal for video
recording start.
*) In Simple mode is not supported.
In & Out
Direction
Rect Detect object moving. From left to enter of
area, detecting direction of moving out.
*) Please don’t use as a signal for video
recording start.
*) In Simple mode is not supported.
In & Out
Direction
Rect Detect object moving. From bottom to enter of
area, detecting direction of moving out.
*) Please don’t use as a signal for video
recording start.
*) In Simple mode is not supported.
Move
Clockwise
Line Event will occur the object moves in a
clockwise direction that start around.
*) Please don’t use as a signal for video
recording start.
Move Conter-
Clockwise Line Event will occur the object moves in a counter-
clockwise direction that start around.
*) Please don’t use as a signal for video
recording start.
Path Event : Detect route between two zones. (Max.10 path detection is possible).
NOTE:
* Disabled zone can not be configured.
* In Simple mode is not supported.
* The result of path event detection can be inaccuracy.
Output Direction Setup
: same as zone output configuration.
Clear All : All path combinations clear.
2) Env.Setup(Environment setup)
: Configurations for each PVA functions.
- Md Sens(MD Sensitivity) : Adjust motion sensitivity.(HW sensitivity)
- Loiter Time (min): Time for judge to loitering object.
- Abandon/Absent Setup
Sens(Sensitivity) : Adjust sensitivity of abandon/absent detection.
Det Time (min): Time for judge to absent/abandon area.
Rst Time (sed): Time for maintain event. After this, background will be update.
- Scn Chg Setup (Scene Change Setup)
Sens(Sensitivity) : Adjust sensitivity of scene change detection.
Chg Ratio: Adjust judgment ratio that changed from the stored background.
Det Time (sec)
: Time for judge scene changing.
Rst Time (sec): Time for maintain event. After this, background will be update.
Unfocus : Detection on/off of unfocused state/defocused state.
- Windy Setup (Windy Area Detection Setup) : Not applied in Simple PVA mode
Sens(Sensitivity)
: Adjust sensitivity of windy object detection.
Det Time (sec)
: Time for judge to windy object.
18