Seametrics PD10 - Manual (Page 3)

PD10 PULSE DIVIDER
To adjust divider , disconnect from power then remove cover and set switches
If a metering pump is used that requires a connection other
than the LMI connector supplied, cut the LMI connector off.
Connect the PD10W to the pump using the diagram below in
conjunction with the wiring diagram in the pump manual.
The input connector on the control mates with any three-pin
Seametrics connector. (Meters or flow sensors to be used with
a PD10W should be ordered with Seametrics connectors.)
1
2
3
Page 3
INSTALLATION & CONNECTIONS
The PD10M is factory-mounted on the flow sensor. The PD10W
is mounted by attaching it to the metering pump with the in-
cluded double-backed, pressure-sensitive tape. Alternatively,
the control can be wall mounted with screws using the mount-
ing brackets that extend out either side.
PD10 Meter Mount
SENSOR
POWER
S
+
-
+
-
0 1 2
3
45 67
8
9 0 1 2
3
45 67
8
9 0 1 2
3
45 67
8
9 0 1 2
3
45 67
8
9
OUTPUT
+
-
PD10M
www.seametrics.com
Flow Sensor
Red
White
Black
Electronic
Metering
Pump
7 - 30 Vdc
Power Supply
+
-
LMI Pump
MOUNTING
CONNECTIONS
The PD10 meter mount can be connected as shown.
PD10W/LMI PUMP
The 24" pigtail that extends from the PD10W connects to an
LMI metering pump and is connected as shown.
The input connector on the control mates with any three-pin
Seametrics connector. (Meters or flow sensors to be used with
a PD10W should be ordered with Seametrics connectors.)
PD10W/LMI Pump
Sockets
1. Ground
2. Input Signal
3. Sensor Power
+7-30 Vdc*
Sockets
1
2 4
3
LMI Connector
(supplied with
PD10W)
Seametrics
Sensor
Connector
(order with
flow meter)
1. Auxiliary Power Source
2. Pulse Input
3. Ground
4. No Connection
PD10W/NON-LMI PUMP
PD10W/Non-LMI Pump
PD10
Red
Black
Green
White
7-30 Vdc
Ground
Signal +
Common
PD10W
Meter
PD10M meter mounted version
Power for the PD10 can be supplied by the metering pump if
the pump has a sensor power supply. This is the case with
LMI externally-paced metering pumps. Some pumps require
an external power supply, available from Seametrics. LMI
and Seametrics connectors are available.
CAUTION:
Power supplies 18 Vdc and higher must be regulated to
prevent damage to the PD10 from voltages exceeding it's
30 V allowable maximum supply voltage caused by AC line
variations and light loading.
POWER SOURCE
POWER
OUTPUT
+
–
+
–
*CAUTION: If power is supplied to the flow sensor from the
PD10, ensure that the voltage supplied to the sensor does not
exceed the sensor's allowable maximum input voltage.
2
3 1
4
5
-06 Option -106 Option
Sockets
1. Remote On
2. Ground
3. Pulse Input
4. Aux. Power Source
5. Not Used
Black
Red