SHIMPO DT-601CG - Manual (Page 27)

Mode# Alarm output: Setting of alarm output 1 (OUT 1-4)
0 5 * Model with optional line receiver input(L1,L2) cannot output as output terminal will be input
terminal <only LED can react>
A B C D E F
0 5. 0 0
Selection of preset action
0 : plus side 2 stages preset action
1 : ±each stage preset action
2 : batch count action (only the setting with automatic reset)
3 : plus 1 stage and secondary output action
(only the setting without re-output)
Display selection
0 : Display 1
1 : Display 2
<Caution>
Do not select display 2 when selecting A or -A with Mode 00 [measurement calculation method]
[Display selection]
Display 1 : Output against Display 1
Display 2 : Output against Display 2
[Preset action selection]
setting of output action
For the timing chart and setting condition,
refer to [output timing for preset action and setting condition]
* when changing setting, do so as display offset value
and preset value will be included in setting condition.
<Caution>
When Mode 05 to 07 are changed, DO NOT FORGET TO RESET BEFORE STARTING MEASURING.
P25