Thermo Fisher Scientific CyberComm Pro for CyberScan CON 1500 - Manual (Page 16)

Instruction Manual CyberComm CON 1500
12
Icon 11: Meter Settings
See Figure 16.
Program your meter functions via this icon on
CyberComm Program.
a) Temperature
I) Temperature Units of Measurement
- Select °C or °F as required (Default is
°C)
II) Temperature Coefficient
- Select from the range of 0.000 to
10.000
III) Normalised Temperature (°C/ °F)
- Select from range of 15.0 to 30.0°C
OR 59.0 to 86.0 °F
b) Conductivity
I) Auto Calibration
- Select YES or NO (Default is YES)
II) Calibration Type
- Select SINGLE or MULTIPLE (Default
is SINGLE)
c) Resistivity
I) Calibration Type
- Select SINGLE or MULTIPLE (Default
is SINGLE)
d) TDS (Total Dissolved Solids)
I) TDS Factor
- Select from range of 0.40 to 1.00.
II) Calibration Type
- Select SINGLE or MULTIPLE (Default
is SINGLE)
e) Cell Constants
- Select 0.10, 1.00 or 10.00 (Default is 1.00)
f) Stability
Check box to enable the Stability Indicator
g) Good Laboratory Practice Settings
Enter the relevant information for useful future references.
h) Data Transfer
I) Data Transfer Mode
- Select CURRENT or MEMORY (Default is CURRENT)
i)
Reset Conductivity calibration settings to default
Check box & click apply to reset Conductivity calibration settings.
j) Reset Resistivity calibration settings to default
Check box & click apply to reset Resistivity calibration settings.
k) Reset TDS calibration settings to default
Check box & click apply to reset TDS calibration settings.
Click on OK or Apply to save settings whenever there are changes.
Figure 16: Meter Settings