Agilent Technologies N1022A - Manual (Page 5)

1
N1022A Active Probe Adapter
N1022A Active Probe Adapter
The N1022A Active Probe Adapter provides the interface to connect an
Agilent Infiniimax Active Probe to an Agilent 86100-series Infiniium DCA. To
use the N1022A requires that firmware revision A.03.05 or later be installed on
the Infiniium DCA.
The Infiniimax Active Probes include the following: 1131A, 1132A, and 1134A.
Other supported active probes include the 1152A, 1156A, 1157A, and 1158A.
C A U T I O N When using the N1022A, always work at a static-safe work station and wear a
wrist-strap or heel-strap.
Refer to “Static-Safe Workstation” on page 8 .
C A U T I O N The probe adapter connections can be damaged if it is dropped from excessive
heights onto a hard surface.