Blue Angel Pumps ODS10 - Manual (Page 3)

Oil Smart® Switch
Trouble Free Operation
1. Plastic Switch case must be kept clean. Free of: rust, mud, soap, etc. If switch
is submerged in water during initial installation, switch must be cleaned.
2. Clean with Alcohol or an oil base product: kerosene, solvent.
3. Pumps with an attached float switch, Float switch must be removed or
secured in manual operation before attaching the Oil Smart® switch.
4. Mount switch in secure manner to: pump PVC pipe, do not mount to metallic
material.
5. Mount in sump clear of water inlet keeping switch case clean & dry as possible.
6. Keep bottom of long sensor at least two inches above pump inlet (Impellor).
7. Keep sensors one to two inches (1 to 2”) clear of any metallic material.
8. Switch will not function with incorrect polarity (Polarity Sensitive).
9. Supply voltage: 115AC and 240AC For European model.
10. Pump turns on when water covers long and short rod.
11. Test switch: to simulate water, place thumb and finger on sensor rods let go of
short rod and firmly slide finger down long rod, switch will turn off when finger
is clear of long rod.