C-1700n, Warning, Caution – Blue-White C-1700N CHEM-FEED Diaphragm Pump User Manual
Page 4
C-1700N
C-1700N
FIG. 4.2 TYPICAL INSTALLATION
Page 4
Page 5
Discharge
Tube
Pumping unit
Chemical
# 1
¼" & ½" NPT Injector
C-1700N
4-1/2”
9-1/16”
7-5/32”
FIG. 4.0 DIMENSIONAL DRAWING
FIG. 4.1 INJECTOR WALL MOUNTING
4.2
Electrical Connections
4.2.1
Input Power Connections
Note: When in doubt regarding your electrical installation, contact a licensed electrician.
The C-1700N is supplied with either a ground wire conductor and a grounding type attachment plug
(power cord) or a junction box for field wiring.
POWER CORD MODELS -To reduce the risk of electric shock, be certain that the power cord is
connected only to a properly grounded, grounding type receptacle.
JUNCTION BOX MODELS -To reduce the risk of electric shock, be certain that a grounding conduc-
tor is connected to the green grounding conductor located in the junction box.
FIG. 4.4 WIRING DIAGRAM - STANDARD MODELS
AC
MOTOR
INPUT
VOLTAGE
115V 60Hz
HOT
LEADWIRE
NEUTRAL
LEADWIRE
GROUND
LEADWIRE
230V 60Hz
BLUE or YELLOW
BLUE
BROWN
RED
GREEN
GREEN
GREEN
MOTOR LEADWIRES
Neutral
Hot
Ground (green)
Earth Ground (green)
Common
Hot
AC
Input
Power
220V 50Hz
BLACK or YELLOW
BLACK or YELLOW
* Yellow leadwire : thermally protected motor
Black or Blue leadwire: standard impedance protected motor
*
*
*
24V 60Hz
WHITE
GREEN
BLUE
*
#10 Self-Tap
(2 X)
2.30”
Slide in
Clamp
Wall Mount
Chemical
# 2
¼" & ½" NPT Injector
Discharge
Tube
Suction
Tube
Suction
Tube
Risk of chemical overdose. Be certain the pump does not
overdose chemical during backwash and periods of no flow in
the circulation system.
!
WARNING
To prevent chemical overdosing, a flow switch is recommended
on the circulation system to automatically stop chemical feed
when there is no return flow to the swimming pool or spa.
!
CAUTION
SHOCK
!
WARNING
Risk of electric shock.
Be certain to connect the pump to the proper
supply voltage. Using the incorrect voltage will damage the pump and
may result in injury. The voltage requirement is printed on the pump
serial label.
To prevent chemical overdosing, disconnecting power to the
circulation system must also disconnect power to the pump.
!
CAUTION