American DJ 150/RG - Manual (Page 7)

Color 150/RG™ Fuse & Lamp Replacement
Caution: Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
®
technician.
Replacing with anything other than the specified part can damage the
unit and will void the manufactures warranty.
Warning: If, after replacing the lamp or fuse either one continues
to blow, STOP using the unit. Contact customer support for further
instructions, you may have to return the unit for servicing. Continuing
to use the unit may cause serious damage.
Fuse Replacement: Disconnect the unit’s main power supply. Insert
a standard flat head screw driver in to the fuse holder housing. Turn
the screwdriver in counter-clockwise direction to remove the fuse
holder. Remove the fuse holder to expose the fuse. Remove the old
fuse and discard it. Replace the fuse with the same type. Insert the
fuse holder back into it’s housing and turn it in clockwise direction to
lock the holder in place.
Lamp Replacement: Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power and
allow the unit ample time to cool before attempting to replace the
lamp. Lamp replacement has been made simple by incorporating the
use of a flip-up top cover that is retained by a single thumb screw.
1. Be sure to follow the proper handling procedures that deal
with halogen lamps. Never touch the new lamp with your bare
fingers.
2. Remove the single thumb screw located on top of the unit. This
screw holds the flip-up lamp socket assembly cover in place.
3. Flip-up the cover. The cover is on hinges and will not fall off.
4. Carefully remove the old lamp and discard it in the trash.
5. Replace the lamp with an exact match and reassemble.
© American DJ Supply ® - www.americandj.com - Color 150/RG™ Instruction Manual Page 13
Halogen Lamp Warning:
This fixture is fitted with a halogen lamp which
is highly susceptible to damage if improperly han-
dled. Never touch the lamp with your bare fingers
as the oil from your hands will shorten lamp life.
Also, never move the fixture until the lamp has
had ample time to cool. Remember, lamps are not
covered under warranty conditions.
© American DJ Supply ® - www.americandj.com - Color 150/RG™ Instruction Manual Page 14
Color 150/RG™ Gobo Replacement
Color 150/RG™ Halogen Lamp Warning
Flip-Up Lamp Cover
Unit Top Cover
Thumb Screw Retaining Hole
Lamp/Socket Assembly
This unit includes two interchangeable gobos. These gobo may
substituted with any 26mm gobo (20mm viewable). A detailed list of
available gobo for this unit may be found on the American DJ
®
web
site, if you do not have access to the internet please contact customer
support and request a catalog. To change the gobos;
1. Flip unit over so the bottom is facing up.
2. Remove the thumb screw on the rear panel of the unit and slide out
the protective fan grill plate.
3. Removing the fan grill plate will expose an addition thumb screw
that retains the gobo wheel protective cover. Remove this thumb
screw and cover.
4. Once the gobo wheel is exposed, use a small flat head screw drive
to gently push one end of the gobo wheel down. This will expose
the opposite end of the gobo wheel, allowing you to remove a
gobo and replace it with another.
5. Use a small flat head
screwdriver to remove the
gobo retaining ring, this
will allow you to pop out
the gobo.
6. Insert a new gobo and
reassemble in reverse
order.
Unit Bottom
Gobo Wheel Cover
Thumb Screw
Gobo Wheel
Cover
Gobo Wheel
Fan Plate Pro-
tective Plate