AT&T 1855 - Manual (Page 27)

25
Answering System Operation
25
1
Remote access
Dial your telephone number from
any touch-tone phone.
2 When system answers, enter your
3-digit Remote Access Code (500
unless you have changed it).
3 Enter remote commands
(see list at right).
4 Hang up to end call and save all
undeleted messages.
Play messages
1/2
Repeat or go back
4
Skip message
6
Stop
5
Delete message
3
Review announcement
7
Record announcement
*7
to begin recording
5
to stop recording
Record memo
#
to begin recording
5
to stop recording
Press 1 to hear all messages.
Press 2 to hear only new messages.
Press to repeat current message. Press 4
Press to skip to next message.
Press to stop any operation
(stop playback, stop recording).
Press 3 to delete message during playback.
Press 33 to delete all messages.
Press to review current outgoing
announcement.
Press * 7, wait for beep, then begin speak-
ing. Press 5 to stop recording and hear
playback of new announcement.
Press #, wait for beep, then begin
speaking. Press 5 to stop recording.
A 3-digit security code is
required to access your
answering system from any
touch-tone phone.This
code is “500” by default;
see page 21 to change it.
ATT-1855CIB-d05.qxp 4/8/2005 5:39 PM Page 25
Review settings
9
Exit
*9
Press to hear current status of all answering
system settings.
Press to hang up answering system.
Turn system on If off, system will answer after 10 rings. Enter
your access code, then press 0 to turn on.
Turn system off
*0
Review/set day & time
8 /
Press 8 to hear current day & time. Press * 8
to change day & time.
Follow the steps at left to set the day and time.
8
0
Remote access
*
The system uses voice prompts
twice ( 4 4 ) to hear previous message.
to help you set the day, hour and
minute, and year.
1 Press * 8 .
You will hear the current day,
and, "
to change, press
2 Press 4 repeatedly to advance
or press 6 repeatedly to reduce
the value of the setting.
3 When you hear the correct value
for the day, (or hour, or minute,
or year,) press 8 to move to the
next time setting.
4 Repeat steps 2 and 3 to change
each time setting. When finished,
the system will announce the new
day, hour, minute, and year.
6
or
4 . "