Bulletin f-68, Key to set the outputs – Dwyer PUX User Manual
Page 63
9 - 22
(6) ADJUST: when adjusting output circuit (prepare an ammeter)
q
Press the
or
key on the “ANALOG IN/OUT” page and select “ADJUST” from “OUTPUT”.
Press the
ENT
key, and the ADJUST screen is displayed, enabling you to calibrate the output circuit.
w
Select either 4 mA or 20 mA by the
or
key. Adjust the output circuit so that outputs are
adjusted to either 4 mA (0% output calibration) or 20 mA (100% output calibration) by pressing the
or
key.
e
Press the
ENT
key to set the outputs.
2 0 m A
ADJUST
4 m A
4 m A
ADJUST
ADJUST
ANALOG
4 m A
ADJUST
ANALOG
ANALOG
4 m A
ADJUST
2 0 m A
ADJUST
PUSH ENT KEY
ADJUSTED
ADJUSTED
2 0 m A
ADJUST
ENT
ENT
ENT
Adjust output to 20mA
and press .
Transition from
4 mA to 20 mA
or vice versa.
Adjust output
to 4 mA with
an ammeter
and press .
Press .
BULLETIN F-68