Advantech PCM-3601 - Manual (Page 23)

Page: 22
&K5 Unidirectional XON/OFF
&K6 RTS/CTS, XON/XOFF flow
control
&M0 Set modem for async
operation
&P0 M/B ratio 39/61(USA)
&P1 M/B ratio 33/67(UK, Hong
Kong)
&P2 M/B ratio 39/61 at 20 pulses
&P3 M/B ratio 33/67 at 20 pulses
&Q0 See & M0
&Q5 The modem will try to
negotiate an error-corrected
link
&Q6 Select asynchronous
operation in normal mode
&R0 Modem turns CTS on when
detects RTS from the local
computer
&R1 Ignore RTS. Modem turns
CTS on when ready to
receive synchronously
&S0 Modem forces DSR always
on
&S1 Set DSR to follow RS-232
spec
&T0 Terminates test in progress
&T1 Initiates local analog
loopback, V.34 Loop3, Sets
S16 bit0. If aconnect exists
when this command is issued,
the modem hangsup, The
connect xxxx message is
displayed upon the start of
the test.
&T5 Disable digital loopback
acknowledgment for
remote request.
&T8 Initiates local analog
loopback, V.34 Loop3, with
selftest.
&V Display modem profiles and
numbers
&W0 Write ACP to SCP0
&W1 Write ACP to SCP1
&Y0 Designate SCP0 as the
active SCP
&Y1 Designate SCP1 as the
active SCP
&Zn= Save up to three numbers to
NVRAM. Use DS=n to dial
the stored number
Note: &Q,&M: for Sync mode only