Dwyer BPS-015 - Manual

Bulletin PC-BPS
The Series BPS Building Automation Power Supply is used to convert
24 VAC to a regulated DC power source for transmitters with 4 to 20 mA
outputs. The output voltage can be field adjusted from 1.5V to 27V using
a potentiometer. The 3A fuse protects the power supply from over-current
conditions. The snap-on bracket can be quickly surface mounted to any
flat surface.
DWYER INSTRUMENTS, INC.
Phone: 219/879-8000 www.dwyer-inst.com
P.O. BOX 373 • MICHIGAN CITY, INDIANA 46361, U.S.A. Fax: 219/872-9057 e-mail: [email protected]
SPECIFICATIONS
Input: 24 VAC/VDC 50/60 Hz.
Output: 24 VDC (full wave rectified and regulated) adjustable 1.5 to 27
VDC.
Maximum Current Output: 1.5A (de-rated to 400 mA for non-isolated
circuits).
Operating Temperature: 32 to 130°F (0 to 55°C).
Humidity Limits: 95% (non-condensing).
Weight: 0.4 lb.
Specifications - Installation and Operating Instructions
Model BPS-015 Low Cost DC Power Supply
SNAPTRACK
4-1/16
[103.12]
2-19/64
[58.17]
1-15/16
[49.02]
11/16
[17.27]
©Copyright 2009 Dwyer Instruments, Inc. Printed in U.S.A. 7/09 FR# R6-443738-00
CAUTION: TO PREVENT OVERHEATING, THE OUTPUT CUR-
RENT MUST NOT EXCEED THE RATIO OF THE OUTPUT
VOLTAGE TO THE INPUT VOLTAGE TIMES THE RATED
CURRENT.
Example:
For output voltage set at 5 VDC, the output current should not exceed 313
mA.
(5V/24V) x 1.5A = 0.313A
Isolation:
If the DC ground is connected to the AC ground, the fuse will open.
If the AC and DC circuit grounds cannot be isolated, move the shorting
jumper from J1 to J2 and add a shorting jumper to J3. In this case the out-
put current is limited to 400 mA.
OUTPUT
VOLTAGE
ADJUSTMENT
REGULATED
DC VOLTAGE
OUTPUT
LINE VOLTAGE
TRANSFORMER
J1
J2
J3
24 VAC IN
WIRING DIAGRAM
PC-BPS:TEMPLATE 7/9/09 11:14 AM Page 1