Kaman 8000 Enclosures - Manual (Page 27)

27
6)
Install the guide rails. Be sure to space as other guide rails in the unit are
spaced (there should be 5 empty holes between guide rails). The guide rails
snap into place in the upper and lower horizontal parts of the rack.
7) Solder in the power and ground connections. You will need to use 24AWG bus
wire to connect the power and ground of any Kaman supplied module. The back
plane template (fig. 15) shows the power and ground connections.
8)
Solder in connections with insulated bus wire to the display and/or back panel
as required for the application. The wiring template in fig. 15 gives the basic
pinout for measuring channels and function cards. For third party modules
you will have to refer to the specific information provided by the manufacturer.
Typical connections are from the measuring channel out+ (C14/A14) and out-
(A16/C16) to the display module (see the section on Input Wiring to the
Display) or to an available pin on the back panel terminal block. If you are
wiring in a function card you will need to use the measuring channel outputs as
inputs to the function card. Typical function cards have inputs located on
A12/C12 for channel 1 input and A16/C16 for channel 2 input. The location of
the outputs vary depending on the type of output required.
9) Once you have carefully checked the wiring of outputs and inputs connect the
SMA to the back panel and carefully reassemble the unit.