Ouellet OVS - Manual

IMPORTANT
1- Do not obstruct the front of the heater for at least
48 in. (1200 mm).
2- Install the heater with the air outlet at least 10 in. (254 mm)
from
the fl oor or adjacente surface.
3- Do not install the inside of the heater assembled directly in the
wall. Always install the heater in the wall with the recess box.
INSTALLATION INSTRUCTIONS
RECESS WALL MOUNTING;
1- Heater may be installed in any of four vertical positions
as shown on drawing.
2- Provide an opening as shown on drawing, a minimum of
3 in. (76 mm) deep. May be recessed in 2X3 in. stud wall.
3- Remove the appropriate knock-out from the recess box
for the electrical supply. The heater junction box volume
is 35 in. 3 (576 cm 3 ).
4- Install the heater or the recess box and be sure that the heater
is
attached fi rmly with the provided screws. Make sure that the
edge on each side of the recess box lean on the drywall and not
on the structural parts of the wall. See marking on the sides of
the recess box. IMPORTANT: If the recess box is pre-installed,
insert the keyholes of the ventury on the 4 screws of the recess
box and thighten the 4 screws to prevent vibration.
5- Connect the heater leads to the supply leads according to the
wiring diagram of these instructions in accordance with local
and national codes.
6- Install the grille using the provided screws. Make sure that the
fan blade is free to rotate and the heater assembly is free of
foreign objects and/or matter. Make sure that the solid panel
of the grille covers the supply connection box.
7- Test heater by temporaly adjusting the thermostat at maximum
temperature.
SURFACE WALL MOUNTING:
1- Heater (and surface box) may be installed in any of four
vertical positions (See drawing).
2- Locate the power supply leads behind the surface box.
3- Mount the surface box securely to the wall with the provided
screws.
4- Follow instructions 3 to 7 mentioned previously in the recess
wall mounting section.
OPTIONAL THERMOSTAT:
Refer to the instruction supplied with the option.
MAINTENANCE INSTRUCTIONS
- Once a year, remove the front panel and use a vacuum cleaner
to remove the dust accumulation inside the heater.
- Cleaning should be done while the heater is disconnected
from the main service panel. Wait until the housing
and heating element cool before performing maintenance.
- Replace the front panel before energizing.
- Any other servicing should be performed by a qualifi ed
technician.
WARRANTY
OUELLET CANADA INC. warrants the component parts of its
products against defects in material and workmanship for a one year
period following the date of purchase, under normal use and service,
when proof of purchase of such is provided to the manufacturer. The
obligation of Ouellet Canada inc., under the terms of this warranty,
will be to supply a new unit and this releases the manufacturer from
paying the installation costs or other secondary charges linked to
replacing the unit or the component part(s).
Canadian version
American version
180, 3 rd Avenue, L’Islet, Quebec, G0R 2C0, CANADA
Tel.: (418) 247-3947, 1-800-463-7043 Fax: (418) 247-7801
www.ouellet.com
INSTRUCTIONS “OVS” Series
Read carefully these instructions before installation, operation
of the heater. Failure to adhere to the instructions could result in
fi re, electric shock, serious personal injury, and death or property
damage. Review frequently for continuing safe operation and
instruction of future users, if necessary.
IMPORTANT INSTRUCTIONS
- Read all instructions before using this heater.
- This heater is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materials,
like furniture, pillows, bedding, papers, clothes, and
curtains at least 36 in. (915 mm) from the front of the heater.
- Do not use outdoors.
- Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock or
fi re, or damage the heater.
- Do not block air intakes or exhaust in any way whatsoever.
- This heater has hot and arcing or sparking parts inside.
Do not use it in areas where gasoline, paint, or fl ammable
liquids are used or stored.
- Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fi re,
electric shock, or injury.
- AMERICAN VERSION ONLY: This heater includes a visual
alarm to warn that parts of the heater are getting excessively
hot. If the light turns on, immediately turn the heater off and
inspect for any objects on or adjacent to the heater that may
cause high temperatures. DO NOT OPERATE THE
HEATER WITH THE ALARM LIGHT IS ON.
- The thermostat should not be considered as an infallible system
where maintaining a temperature is considered critical.
Examples: Hazardous material storage, computer room, etc.
In these particular cases, it is imperative to add a monitoring
system to avoid the consequences of a failure of the thermostat.
KEEP THESE INSTRUCTIONS.
WARNING
When using electrical appliances, basic precautions should
always be taken to reduce the risk of fi re, electrical shock and
injury, including the following.
INS28-200301-05
358
14 1/8
182
7 3/16
207
8 3/32
179
7 1/16
76
3
206
8 1/8
406
16
407
16 355
13 7/8
DIMENSIONS
mm
inches
Four mounting positions available
Direction of the air outlet
Recess box
Ventury
IMPORTANT:
The Ventury
must be used
with the recess
box.