PATLITE WDR-LE - Manual (Page 58)

56
Wireless Data Aquisition System Comprehensive User's Manual
(3) 0x0230 : Module Setting, Output Strength
Wireless Setting ID Wireless Setting ID Data
Module Setting Output Strength
0x02 0x30
2 bytes 1 byte 1 byte
① ②
① Module Setting ： Upon power-up, the module can be set to automatic boot-up or manual
connection to the network.
Please set for automatic boot-up. （0x00：Automatic Boot-up）
② Output Strength ： Setting for wireless RF output strength.
Setting range is from 0x00 (minimum） to 0x0F （maximum).
Adjust in accordance to the surrounding environment.
(4) 0x0237 : Status Confi rmation Setting (For Receivers with Setting Function）
Wireless Setting ID
Wireless Setting ID Data
Heartbeat Watch
Set
0x02 0x37 0x00 0x00
2 bytes 1 byte 1 byte 2 bytes
① ②
① Heartbeat ： Heartbeat is measured in seconds (sec).
The setting range is from 0x00 to 0xFF.
In the case of setting 0x00, the Status Confi rmation Settting is invalidated.
Please
● If setting the Heartbeat to 0x00, the Watch also has to be set to 0x00.
② Watch ： The setting is for the status confi rmation notifi cation time-out (sec) when
the receiver is checking the transmitter withdrawal.
Set in the range from 0x00 to 0xFF.
When a time-out occurs, after the receiver recognizes the transmmitter
withdrawal, it then issues a withdrawal notifi cation via the LAN or USB
connection.
Please
● When using the Heartbeat setting, use the following formula to stay within the maximum tolerable
settings:
Watch（sec） ＞ Heartbeat（sec）Ч５