PEP Filters HMF2 - Manual (Page 12)

HMF2 Series Filter System
Operating & Maintenance Manual
PEP Filters • 322 Rolling Hill Road • Mooresville, NC 28117 • 800-243-4583 • www.pepfilters.com
12 of 19
Rev. 041204
Safety Precautions
All electrical, mechanical and rotating machinery constitute a potential hazard,
particularly for those not familiar with its design, construction, and operation.
Accordingly, adequate safeguards should be taken whenever working with or near
HMF2 filter systems.
Equipment operation, maintenance and repair should be undertaken by qualified
personnel only. All such personnel should be thoroughly familiar with the
equipment, the associated system and controls, and the procedures set forth in this
manual. Proper care, procedures, and tools must be used in handling, lifting,
installing, operating, maintaining, and repairing the HMF filter system.
For the protection of authorized service and maintenance personnel, the pump motor
associated with this equipment should be installed with a lockable disconnect switch
located in close proximity and within sight of the HMF2 filter. No service work should
be performed on or near the pump motor without first ensuring that the pump motor
has been electrically disconnected and locked out.
The re-circulating water system may contain chemicals or biological contaminants
that could be harmful if inhaled or ingested. Accordingly, personnel exposed to the
mist produced by water jets or compressed air (should these be used to clean
portions or components of the HMF filter) should wear half-face respirators with
HEPA filter cartridges, NIOSH/MSHA approved number TC-21C-142/TC-21C-182.
Warranty Policy
All products manufactured by PEP are warranted to be free from defects in materials
and workmanship for a period of 12 months from date of startup or 18 months after
shipment, whichever is sooner. Contact PEP Filters for further warranty information.