PNI FieldForce Trax - Manual (Page 27)

PNI Sensor Corporation DOC#1016505 r06
TRAX User Manual Page 23
Save
Clicking the <Save> button will save any changes made in TRAX Studio to the
TRAX’s onboard non-volatile and volatile memory.
Apply
Selecting the <Apply> button will apply any changes to the TRAX’s volatile
memory, but not to the non-volatile memory. If the TRAX is powered off/on, the
settings will revert to whatever was last saved in the non-volatile memory.
Read
Clicking the <Read> button will read the current settings in the TRAX’s volatile
memory and display them. This will change any item in bold, which indicates a
setting was changed in TRAX Studio but not applied to the TRAX’s volatile memory,
back to regular type and the setting change will not be applied to the TRAX’s
memory.
Default
Selecting the <Default> button will display the default settings, which are stored in
TRAX Studio. Selecting this button will not automatically apply these values, and
either <Apply> or <Save> must be selected for the read values to be applied.
6.4 Configuration Tab
The Configuration Tab is shown below and its contents discussed in the following
subsections. For any changes to take effect, the <Save> button must be selected. Clicking
on the <Default> button will load the factory default values, although these must be saved to
take effect. Clicking the <Retrieve> button will show the current settings of the device.