PNI Legacy Comm Board - Manual (Page 13)

PNI Corporation 133 Aviation Blvd., Suite 101, Santa Rosa, CA 95403-1084 USA;, Fax: (707) 566-2261
For the most current specifications, please visit our website at:
www.pnicorp.com
Page 13 of 42
CommBoard
Action Commands
ACTION COMMANDS
factory (Factory Settings Restore)
Restores the CommBoard and modules to the factory default configuration.
Syntax:
factory<es>
Response Format: $factory*<dcs><er>
go (Continuous Output)
Instructs the CommBoard to enter continuous mode. The CommBoard will begin sampling
sensors at the rate specified by the Polling Frequency (pollfreq) command.
Syntax:
go<es>
Response Format: $(select data)*<dcs><er>
Notes: Stopped using the h command
h (Halt Continuous Output)
Instructs the CommBoard to exit the continuous output mode.
Syntax:
h<es> if halt = d see halt command
h if halt = e
Response Format: $h*<dcs><er>
help or ? (Help Menu)
Instructs the CommBoard to display the Help menu.
Syntax:
help<es> or ?<es>
Response Format: Menu Data