Prochem Crew Chief - Manual (Page 16)

16
Operations
Equipment Setup
Powering the Crew Chief
1. Place the Crew Chief in the center of a building or area to be restored. If an ungrounded 240 V supply is to be
used, locate within 10' of the grounded outlet and connect the ground jumper there.
2. Connect the Crew Chief to grounded electrical supply source(s). Use UL certified undamaged power cords
appropriate to carry 120V 15 Amps or 240V 50 Amps of continuous power. Plug in a single 240V cord and/or
multiple 120V cords.
Discharge personal static build-up by touching a face screw before touching switches or plugging in elec-
tronic cables. Otherwise component damage to switches and PCBs may occur.
Libérer l'énergie statique personnelle en touchant une vis faciale avant de toucher les commutateurs ou de
brancher les câbles électroniques. Sinon, les composants des commutateurs ou des PCB peuvent
s'endommager.
3. Select the power input 120V or 240V on the Voltage Selection Knob. All outgoing power is 120V.
4. When 240V supply is used then all the front 120V GFCI Electrical outlets are live. When 120V supply cords are
used then only the outlet immediately above the input is live.
To access environmental condition data remotely:
1. Call PROCHEM customer service @ 1-800-776-6363 to set up your Crew Chief internet account. This only
needs to be done once. Then you will have access to crewchief.prochem.com website. An account allows
uploading, storing and remote access to environmental condition data.
2. Connect Crew Chief to internet source via ethernet port on back panel.
Sensors and probes
1. Ensure that the sensors have good fully charged batteries. Sort by color and designate a room or zone for
each color of sensor.
2. Screw probes into building structure that are most suspect of being wet.
3. Plug the probes' connection cables into the sensors' cable connection ports. Every probe needs a sensor to
power it and relay data to the Crew Chief.
4. Use the Quick Start Process, turning on the sensors and setting the broadcasting channels when indicated in
the process.
86339940 Crew Chief