Sterlco SIT Inventory Monitor Units - Manual (Page 4)

SIT Series
Inventory & Density Monitor Unit
4
; Disconnect and lock out power and compressed air before attempting to clean out
an auger and slide gate area.
; NEVER PUT FINGERS OR TOOLS IN AN AUGER OR SLIDE GATE AREA.
; Make sure the components are properly GROUNDED before you switch on power.
; Do not jump or bypass any electrical safety control.
; Do not jump or bypass any pneumatic safety control.
; Do not restore power until you remove all tools, test equipment, etc. and until the
blender and related equipment is fully assembled.
; Only PROPERLY TRAINED personnel familiar with the warnings and instructions in
this manual should work on this equipment.