Timeguard EL17 - Manual (Page 7)

26
iii Press <Program> button once – the first ON time is
now set and display shows ready for the first OFF
programme time.
iv Now set the hrs and minutes as before.
v Repeat steps i to iv to set the remainder of the 3 ON/OFF times as required.
Note: Any unused ON/OFF programme should be skipped until the
display shows normal operating mode. Do not programme ‘0’s into
unused programmes.
IMPORTANT After setting a clock time which falls within a programmed ON
period, the unit will not switch ON. Use the override facility to switch unit ON.
After this the unit will operate normally to the programmes set.
4. Programme Review
To fast review the set programmes or for quick exit to normal
operating mode – press and hold the <Program> button.
5. Initiating Programme Mode
This can be initiated any time during the normal operating mode.
Press <Program> button and the Clock symbol, hrs and minutes symbols
on the display will flash – this is review mode. If any change to programmes
is required press <Change> button to initiate programme mode and then
follow steps 2 and 3.
6. Cancelling Programmes
Any ON/OFF programme can be cancelled by clearing its ON and OFF time.
Follow step 5 and when into the ON or OFF programme to be cancelled press
the <Change> button until the hour digits show --:
then press the <Program> button to clear the
programme. The display will show the hour
and minute digits and ON or OFF flashing.
Self Cancelling Override
To change the output status from ON to OFF or vice versa during normal operation
press the <Change> button. The output status will change and indicate override is in
operation by flashing.
1 2 3 4
1 2 3 4