Audiovox PEQ-200 - Manual (Page 9)

-9-
bp
HIGH PASS OUT FRONT R/L CONNECTORS
These connector ports provide the high-pass crossover stereo
output signal to the front speaker amplifier. The crossover
equalization frequency of this signal is selected by the FRONT
crossover selector switch (item 19).
bq
HIGH PASS OUT REAR R/L CONNECTORS
These connector ports provide the high-pass crossover stereo
output signal to the rear speaker amplifier. The crossover
equalization frequency of this signal is selected by the REAR
crossover selector switch (item 18).
br
SUBWOOFER OUT R/L CONNECTORS
Thses connector ports provide the subwoofer crossover ste-
reo output signal to the subwoofer amplifier. The crossover
equalization frequency of this signal is selected by the
SUBWOOFER selector switch (item 20).
bs
INPUT POWER CONNECTOR
This 4-pin connector accepts vehicle input power of 12Vdc
and ground, along with the remote turnon, via the supplied
harness.
bt
REAR HIGH-PASS CROSSOVER SWITCH
This 4-position slide switch allows you to select the high-pass
crossover point for the rear speakers at 150Hz, 100Hz, 80Hz
or FULL (Full Range) during 2-way and 3-way operation. The
frequencies above the setting of this control will be passed
through the crossover to the HIGH PASS OUT REAR R/L
jacks. Make this selection as appropriate for the woofer-to-
midrange frequency of the speaker system being used.
SUBWOOFER REAR FRONT
FULL
80Hz
100Hz
150Hz 200Hz
150Hz
100Hz
FULL
120Hz
100Hz
80Hz
50Hz
CROSSOVER-EQUALIZER
INPUT
R L
INPUT
LEVEL
L R
FRONT
OUT
REM B+
GND L
REAR
HIGHPASS
OUT R
SUBWOOFER
OUT L R _
12 13 14 18 15 16 17
19 20
REAR PANEL