Ultravation UMX 24 EZUV - DC-OH-0224 - Manual (Page 2)

Ultravation.com
DC-OH-0224 REV A
Important!
Read before installation
Lamp Lead (rubber
sleeved female
receptacle)
Note that lamp pin
pattern is NOT square.
It can be mounted from either side
and top or bottom depending on
the orientation of the installed lamp.
Electrical
NOTICE: All 24 volt UV
equipment for HVAC
systems (regardless or
manufacturer) must be
installed using a separate,
dedicated minimum 40VA
transformer to avoid the
possibilty of voiding UL
certification of the HVAC
system.
IMPORTANT: Some EZUV
models are equipped with an
in-line fuse for both surge
and electrical arc protection.
Replace only with equal
value fuse (available from
Ultravation or authorized
distributor, part number
EL-PP-0001).
Failure to do so will defeat
the design and void the
warranty.
The screw holes on the UV Lamp
need to be parallel to the Lamp Lead
cord on the back of the female
receptacle for correct assembly!
Lamp screw holes and Lamp Lead
cord need to be parallel
UVC Lamp
Horizontal orientation of
the lamp lead requires
installing the lamp with
screws left to right.