Brother MW-260 - Manual (Page 24)

24
ESC g Specify micron pitch
[ASCII] ESC g
[Decimal] 27 103
[Hexadecimal] 1B 67
[Parameters] None
[Description]
・ Prints the following data (ANK characters) using micron pitch (15 characters/inch).
ESC p Specify proportional characters
[ASCII] ESC p n
[Decimal] 27 112 n
[Hexadecimal] 1B 70 n
[Parameters] n=0, 1 or 30h, 31h
[Description]
・ Specifies proportional characters.
・ If n=1 or 31h, proportional characters are applied.
・ If n=0 or 30h, proportional characters are cancelled.
ESC W Specify double-width characters
[ASCII] ESC W n
[Decimal] 20 87 n
[Hexadecimal] 1B 57 n
[Parameters] n=0 and 1 or 30h and 31h
[Description]
・ Specifies double-width characters.
・ If n=1 or 31h (“1”), double width is applied.
・ If n=0 or 30h (“0”), double width is cancelled.
SO Specify auto-cancelling enlarged characters
[ASCII] SO
[Decimal] 14
[Hexadecimal] 0E
[Parameters] None
[Description]
・ Prints the following data in double-width characters.
・ This mode is cancelled using DC4, LF, VT, FF, or an automatic line feed.