Brother MW-260 - Manual (Page 29)

29
2-3) Line feed amount commands
ESC 0 Specify line feed of 1/8"
[ASCII] ESC 0
[Decimal] 27 48
[Hexadecimal] 1B 30
[Parameters] None
[Description]
・ Specifies a line feed amount of 1/8" (approximately 0.32 cm).
・ A line feed sets 38 dots (38 dots / 300 dpi).
ESC 2 Specify line feed of 1/6"
[ASCII] ESC 2
[Decimal] 27 50
[Hexadecimal] 1B 32
[Parameters] None
[Description]
・ Specifies a line feed amount of 1/6" (approximately 0.42 cm).
・ A line feed sets 50 dots (50 dots / 300 dpi).
ESC 3 Specify line feed amount in minimum units
[ASCII] ESC 3 n
[Decimal] 27 51 n
[Hexadecimal] 1B 33 n
[Parameters] 0≤n≤255
[Description]
・ Specifies a line feed amount of n/300" each text line.
ESC A Specify line feed amount of n/60"
[ASCII] ESC A n
[Decimal] 27 65 n
[Hexadecimal] 1B 41 n
[Parameters] 0≤n≤255
[Description]
・ Specifies a line feed amount of n/60".
・ Therefore, n=1 will feed 5 dots (n 1 = 5 dots / 300 dpi).