Brother TD-2120N User Manual
Software developer's manual
Advertising
Table of contents
Document Outline
- Introduction
- About Raster Commands
- 1. Printing Using Raster Commands
- 2. Print Data
- 3. Print Command List
- 4. Printing Command Details
- NULL Invalidate
- ESC @ Initialize
- ESC i S Status information request
- ESC i a Switch dynamic command mode
- ESC i U Additional media information command
- ESC i z Print information command
- ESC i M Various mode settings
- ESC i d Specify margin amount (feed amount)
- M Select compression mode
- g Raster graphics transfer
- Z Zero raster graphics
- FF Print command
- Control-Z Print command with feeding
- 5. Flow Charts
- 5.1 Concurrent printing normal flow for USB connection
- 5.2 Concurrent printing error flow for USB connection (when feeding at the end of the page)
- 5.3 Concurrent printing error flow for USB connection (with a concurrent printing error such as end of tape)
- 5.4 Concurrent printing cooling flow for USB connection
- 5.5 Concurrent printing waiting for peeling/resumed flow for USB connection
- 5.6 Buffered printing normal flow for serial/USB connection
- 5.7 Buffered printing error flow for serial/USB connection
- 5.8 Buffered printing cooling flow for serial/USB connection
- 5.9 Buffered printing waiting for peeling/resumed flow for serial/USB connection
- 5.10 Buffered printing normal flow for network (standard TCP/IP port) connection
- Appendix A: USB Specifications
- Appendix B: Introducing the Brother Developer Center