Brother TD-2120N - Manual (Page 15)

Raster Command Reference
- 11 -
2. Print Data
Descriptions for the numbers in the print data on the previous page are provided in the following table.
For details on each command, refer to “ 4. Printing Command Details ”.
No. Command Name Description
１ Invalidate A 200-byte invalidate command is sent.
2 Initialize The “initialize” command is sent.
3
Switch dynamic
command mode The printer is switched to raster mode.
Send this command before sending raster data to the printer.
4
Job ID setting
commands
Internal specification commands
Since this is a command for outputting with the commercial
version driver, it is unnecessary for the user to send this
command.
5
Additional media
information command Additional media information on the media size is sent.
This is the command for “2.0" × 1.0" (51 mm × 26 mm)”.
6
Print information
command
Media size information for the print data is sent.
This is the command for “2.0" × 1.0" (51 mm × 26 mm)” die-cut
labels.
7
Various mode settings
(1Bh+69h+4Dh+00H)
This is a command for specifying a mode.
In this case, the peeler function is enabled.
8 Specify margin amount
Since a margin amount cannot be specified with die-cut labels,
this command is sent with a margin amount of 0.
9
Select compression
mode
TIFF compression mode is selected.
10 Raster data Raster data continues.
11
Print command with
feeding Since one page will be printed, this is sent at the end of the first
page.