ALESIS DM5 - Manual (Page 7)

5
Putting It All Together
Step 1: Building the base
Lay the rack’s “G” section on the ground and connect
the two “F” sections as shown in the picture. Each
“F” section should have an open socket that faces up.
Tighten all thumb screws to be finger-tight.
Step 2: Building the rack
First, connect the “J” and “K” cross sections to the
“H” side section. Now connect the other ends of “J”
and “K” to the “I” section. Tighten all thumb screws
to be finger tight.
The “H” bar on the left should have two connectors
free and the “I” section on the right should have one
connector free. Also, the endcaps on sections “H” and
“I” should be facing upwards.
Step 3: Connecting the rack to the base
Now connect the main rack assembled in step 2 to the
base assembled in step 1. There are two open
connectors facing up on the base. The bottom of
sections “H” and “I” on the rack should fit nicely into
the two connectors on the base.
.=
Step 4: Attaching the arms
Attach the two arms as illustrated in the diagram to the
left. Both arms are identical. The arm on the left
attaches to the open connector at the top of section
“H”. The arm on the right attaches to the open
connector on section “I”. Make sure that the endcaps
of both arms are facing outward.