Brother TD-4100N - Manual (Page 28)

ESC g Specify micron pitch
[ASCII] ESC g
[Decimal] 27 103
[Hexadecimal] 1B 67
[Parameters] None
[Description]
・ Prints subsequent data with micron pitch (15 characters/inch).
・ Character spacing is 20 dots (=300dots/15 characters).
・ If the character width is 20 dots or less, character spacing is set to 20 minus the
character width.
・ If the character width exceeds 20 dots, character spacing is set to character width. (The
character spacing is 0 dot.)
In this case, the pitch does not exactly equal the micron pitch.
・ With double-width characters, the character spacing is doubled (40 dots).
・ With half-width characters, the character spacing is reduced to 10 dots.
・ When the character spacing is changed with ESC SP, the setting is updated.
・ This command is invalid when proportional pitch is selected.
・ In out-line fonts, the space between character is 0 dot.
[Example] For an 11-dot font at full width
28
Ａ Ｂ
9 dots
11 dots
Ａ Ｂ
22 dots
18 dots
Full width Double width