Brother NX-2000 - Manual (Page 10)

8
a
Loosen the screw on the guide plate sliding
the plate to fit the width of the braid.
a Plate
b
Insert the braid through the guide before
attaching the foot onto the machine.
c
Tighten the screw and pull the braid to the
back of the braiding foot.
d
Attach the foot onto the machine.
e
Select the desired stitch and sew in a circular
manner gently guiding the braid.
■ CORDING FOOT
You can embellish using 1 to 3 cords of decorative
threads or yarn.
a
Slip a cord from the right of the presser foot,
into each guide (to use single cord, use the
center guide).
b
Place the cords under and to the back of the
cording foot.
c
Select a zigzag or decorative stitch and sew in
a circular manner gently guiding the cords.
Note
• When sewing with zigzag or decorative stitches,
adjust the stitch width, so that it is slightly wider than
the width of the braid or cording.