ArvinMeritor MERITOR TE9000 - Manual (Page 2)

2
TE9000 / 93000 Service
Section Description Page
THE MERITOR WARRANTY 3
THE AXLE IDENTIFICATION PLATE 4
Identifying the Axle Type, Identifying the Serial Number
INTRODUCTION TO THE TE9000 AND TE9300 SERIES AXLES 5
AXLE INSTALLATION 5
Limitations of Use, Stresses and Welding
MAINTENANCE SCHEDULE 6
Torque Recommendations, Recommended Lubricants
1 SERVICE PROCEDURES 7
AXLE ANNUAL SERVICE AND SERVICE AFTER 3 YEARS OR 300,000 KM
De-adjust Brake, Remove Wheel, Hub and Drum Assembly, Remove Brake Shoes,
Remove Anchor Pins, Clean Anchor Pin Bushes, Anchor Bracket and Cam Head,
Clean Spindle, Remove Cam Rollers from Brake Shoes, Clean Cam Rollers and Anchor Pins,
Assemble Anchor Pins, Inspect Brake Linings, Clean and Assemble Brake Shoes,
Inspect Brake Springs, Inspection of Camshafts and Camshaft Bearings for Play,
Removal of Camshafts and Camshaft Bearings,, Replacement of the Camshafts and
Camshaft Bearings, Refit Brake Shoes, Grease Camshaft Bearings, Inspect Brake Drums,
Remove Oil Seal, Wheel Bearing Inspection and Greasing, Routine Annual Hub Service,
3 Year/300,000 km Major Hub Service, Apply Anti-fretting Paste to Spindle,
Refit Hub, Drum and Wheel Assembly, Lubricate Brake Chamber Clevis Pin Assembly,
Adjust Brakes
2 ADDITIONAL PROCEDURES 16
AFTER 3 YEARS OR 300,000 KM
Removal and Refitting of Wheel Bolts, Fitting of the Pole Wheel, Fitting of the Sensor,
Sensor Output, Removal and Refitting of Dust Covers, Fitting of a Hubodometer,
Removal and Refitting of Brake Drum, Removal and Fitting of Antilock Equipment
INDEX