Brother PE-DESIGN Ver.7 - Manual (Page 15)

13
Installation
System Requirements
Before installing the software on your computer, make sure that the computer meets the following
minimum PC requirements.
Computer IBM-PC or compatible computer
Operating system Windows ® 2000, XP
Processor Pentium III 800 MHz or higher
Memory 128 MB (512 MB or more is recommended.)
Hard disk free space 200 MB
Monitor SVGA (800 x 600), 16-bit color or higher
Port 1 available USB
Printer
A graphic printer that is supported by your system
(if you wish to print your images)
CD-ROM drive Required for installation
Note:
• Power is supplied to the USB card writer module through the USB connection. Connect the USB
card writer module to a USB connector on the computer or to a self-powered USB hub that can
supply enough power to the card writer module. If the card writer module is not connected in this
way, it may not operate correctly.
• This product may not operate correctly with some computers and USB expansion cards.
Step 1: Installing the Software
This section describes how to install the application software.
Note:
• If the installation is interrupted or
not performed as described, the
software will not be installed cor-
rectly.
• Before turning on the computer,
be sure to DISCONNECT the USB
card writer module.
• In order to install the software, you
must log on to the computer using
an account with administrator
privileges.
Insert the enclosed
CD-ROM into the
computer’s CD-ROM
drive.
PED7_QSG.indb Sec1:13 PED7_QSG.indb Sec1:13 02.06.2006 20:07:00 02.06.2006 20:07:00