Brother PE-DESIGN Ver.7 - Manual (Page 21)

19
Installation
c
Follow the instructions of the Found New
Hardware Wizard (or Add New Hardware Wiz-
ard) to complete the installation of the driver.
d
Remove the CD-ROM from the computer’s
CD-ROM drive.
Step 3: Upgrading the USB Card Writer Module
This section describes how to upgrade the USB card writer module
for version 7. Users upgrading from version 5 or 6 must upgrade
the card writer. After installing version 7, immediately follow the
procedure below to upgrade the card writer for version 7.
a
Start up Layout & Editing.
→ The dialog box shown below appears.
Note:
• In order to upgrade the USB card
writer module, you must be able to
connect to the Internet. If you can-
not connect to the Internet, contact
your authorized dealer or Brother
Customer Service.
→ The Upgrade wizard starts up, and the fi rst dialog box
shown below appears.
To begin the upgrade, click Upgrade now.
Click Next.
PED7_QSG.indb Sec1:19 PED7_QSG.indb Sec1:19 02.06.2006 20:07:06 02.06.2006 20:07:06