Brother MFC-8870DW - Manual (Page 49)

Installing the Driver & Software
47
Macintosh
®
Ma
c
in
tos
h
®
W
irel
ess
Netw
o
rk
2
Plug in the power cord and turn on the
machine.
Improper Setup
If you have previously configured the wireless
settings of the machine you must reset the
network (LAN) settings before you can
configure the wireless settings again.
Press Menu, 6, 2, 4 (or Menu, 6, 0) and then
press 1 to accept the change.
3
On your machine, press Menu, 6, 2, 2, 1.
22. Setup WLAN
WLAN Enable?
a
On
b
Off
Select ab & OK
Press or to choose On (or Off),
then press OK. The wired network interface will
become inactive with this setting.
4
The machine will search for your network and
display a list of available SSIDs. You should
see the SSID you wrote down earlier. If the
machine finds more than one network use the
or keys to choose your network,
then press OK. Go to step 8.
22. Setup WLAN
SSID
a
salesgroup
b
ABCgroup
Select ab & OK
Note
It will take a few tens of seconds to display a list of
available SSIDs.
If your access point is set to not broadcast the
SSID you will have to manually add the SSID
name. Go to step 5.
5
Select <NEW SSID> using or and
press OK. Go to step 6.
22. Setup WLAN
SSID
<NEW SSID>
Select
ab & OK
6
Enter a new SSID. For information how to type
text, see “Entering Text” in Chapter D of the
User’s Guide.
22. Setup WLAN
SSID:
Enter & OK key
7
Press or to choose
Infrastructure
, then press OK.
8
Use the , and OK keys to choose
one of the options below: If your network is
configured for Authentication and Encryption
you must match the settings used for your
network.
No Authentication or Encryption: Choose
Open system
, press OK then choose None
for Encryption Type and press OK. Then
press
or to choose
1.Yes
and
press OK to apply your settings. Go to step 12.
No Authentication with WEP Encryption:
Choose Open system, press OK then use the
or to choose WEP for the
Encryption Type
and press OK. Go to
step 9.
Authentication with WEP Encryption:
Choose Shared Key, press OK. Go to step 9.
Authentication with WPA-PSK (TKIP or AES
Encryption): Choose WPA/WPA2-PSK,
press OK. Go to step 10.
Authentication with LEAP: Choose LEAP,
press OK. Go to step 11.