Brother MFC-6490CW - Manual (Page 26)

26
Macintosh
® Wired Network
For Wired Network Interface Users (For Mac OS
®
X 10.2.4 or greater)
15
Before you install
a
Make sure your machine is connected to the
power and your Macintosh
®
is ON. You must
be logged on with Administrator rights.
16
Connect the network
cable
a
Lift the scanner cover into the open position.
b
Connect the network cable to the LAN socket
marked with a
symbol. You will find the
LAN socket inside the machine on the left as
shown below.
c
Carefully route the network cable through the
trench and out the back of the machine.Then,
connect the cable to your network.
Important
• For Mac OS ® X 10.2.0 to 10.2.3 users,
upgrade to Mac OS
®
X 10.2.4 or greater. (For
the latest information for Mac OS ® X, visit
http://solutions.brother.com/)
• Make sure there are no memory cards or a
USB Flash memory drive inserted.
• If you have previously set up your machine
for a wireless network and then want to set
it up on a wired network, you should check
that the machine’s Network I/F is set to
Wired LAN. The wireless network interface
will be inactive with this setting. On your
machine, press Menu.
Press a or b to choose Network and press
OK.
Press a or b to choose Network I/F and
press OK.
Press a or b to choose Wired LAN and press
OK.
Press Stop/Exit.
Important
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
If both USB and LAN cables are being used,
guide both cables through the trench with one on
top of the other.
LAN USB