Brother HL 3070CW - Manual (Page 47)

Driver and Software
37
2
Print Quality
2
You can choose the following print quality settings.
Normal
600
×600 dpi. Recommended for ordinary printing. Good print quality with reasonable print speeds.
Fine
2400 dpi class. The finest print mode. Use this mode to print precise images such as photographs. Since
the print data is much larger than in normal mode, processing time / data transfer time and printing time
will be longer.
Note
• The print speed will change depending on what print quality setting you choose. Higher print quality takes
longer to print, while lower print quality takes less time to print.
• (HL-3040CN only) If you choose Fine, the LCD may show Out of Memory because the printer’s memory
is full. If you still get the same error message after you try printing several times, add more memory. (See
Installing extra memory on page 100.)
Color/Mono
2
You can change the Color/Mono settings as follows:
Color
When your document contains color and you want to print it in color, select this mode.
Mono
Select this mode if your document has only black and grayscale text and/or objects. If your document
contains color, selecting Mono mode prints your document in 256 levels of gray.
Auto
The printer checks the content of your documents for color. If color is detected, it prints in color. If no color
content is detected, it prints in monochrome. The total printing speed may become slower.
Note
If the Cyan, Magenta or Yellow toner reaches the end of its life, choosing Mono will allow you to keep
printing as long as the Black toner does not reach the end of its life.