Brother Innov-is 6000D - Manual (Page 19)

18
o
Using both hands affix the second embroidery
positioning mark within the red lines by
pressing down on each corner of the
positioning mark onto the material and then
touch .
→ The camera detects the second positioning sticker.
p
After the two positioning stickers have been
detected, the following message appears.
a Embroidering area
While making sure that the two positioning
stickers do not peel off, remove the
embroidery frame from the machine, and
then rehoop the fabric. Be sure to hoop the
fabric so the next pattern and both the
positioning stickers are within the embroidery
sewing area. Reattach the frame and press
.
a Pattern to be embroidered next
b Centers of large circles for stickers
c Embroidery sheet
Note
• If the machine detects that the next pattern and the
centers of the large circles of the two positioning
stickers do not fit within the embroidering area, the
operation will be paused. Follow the on-screen
instructions to reposition the positioning stickers.
Refer to “Changing the Position of a Sticker” on
page 22 to reposition the stickers.
• If the sticker peels off during this procedure, the
patterns cannot be connected. If this occurs, restart
the procedure from the beginning.
a