Brother Innov-i - Manual (Page 129)

Care and Maintenance 127
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
4
h
Insert the bobbin case so that the S mark on
the bobbin case aligns with the z mark on
machine as shown below.
• Align the S and z marks.
a S mark
b z mark
c Bobbin case
• Make sure that the indicated points are
aligned before installing the bobbin case.
CAUTION
i
Insert the tabs on the needle plate cover into the
needle plate, and then slide the cover back on.
a Needle plate cover
j
Install the flat bed attachment in its original
position.
Removing the needle plate
When the thread is tangled and cannot be removed
by cleaning the race, remove the needle plate.
a
Follow steps
a
through
f
on page 126.
b
Remove the needle plate by removing the
screws with the included screwdriver.
c
Remove the tangled thread from the needle
plate.
d
Return the needle plate to its original position, and
then tighten the screws with the included screwdriver.
Note
z Align the two screw holes on the needle
plate with the two holes on the machine.
e
Follow steps
g
through
j
(page 126-127).
● Never use a bobbin case that is scratched,
otherwise the upper thread may become
tangled, the needle may break or sewing
performance may suffer. For a new bobbin
case (part code: XE7560-001), contact your
nearest authorized service center.
● Be sure that the bobbin case is correctly
installed, otherwise the needle may break.
a