Brother Innov-i - Manual (Page 144)

APPENDIX
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
142
Error messages
If (start/stop button) is pressed before the sewing machine is correctly set up or if an operation is performed
incorrectly, an icon indicating the error appears in the LCD. Follow the instructions that appear. The icon will
disappear if (OK key) or (Cancel/clear key) is pressed while the icon is displayed.
Error
Code No.
Error Message Probable Cause
E1
The motor locked up because the thread is tangled.
E2 The start/stop button or reverse/reinforcement stitch button was pressed
while the presser foot was raised.
E3
The reverse/reinforcement stitch button or needle position button was
pressed, or the foot controller was operated while the bobbin winder
shaft is moved to the right.
E4 The start/stop button was pressed while the foot controller was
connected.
E5 A stitch other than the buttonhole or bar tack stitch was selected and
the start/stop button was pressed while the buttonhole lever is lowered.
E6 The buttonhole or bar tack stitch was selected and the start/stop button
was pressed while the buttonhole lever is raised.
E7 The start/stop button or reverse/reinforcement stitch button was pressed
after a stitch has been deleted.
E8
The bobbin winder is winding the bobbin.
E9 You tried to combine more than 35 character stitches and utility
decorative stitches.
E10
The start/stop button was pressed without connecting the foot controller
while the setting for adjusting the stitch width using the sewing speed
controller is set to [ON].
E11 The twin needle setting is selected while a pattern that cannot be sewn
with the twin needle is selected.