Brother HL-4570CDW - Manual (Page 14)

14
Macintosh
Wired Network
For Wired Network Interface Cable Users for Macintosh
7
Before you install
a
Make sure your machine is connected to the
power and your Macintosh is ON. You must be
logged on with Administrator rights.
b
Remove the protective cap from the LAN
connector.
c
Connect the network interface cable to the LAN
connector marked with a symbol and then
connect it to a free port on your hub.
d
Make sure the machine power switch is on.
8
Install the printer driver
a
Put the installation CD-ROM into your
CD-ROM drive.
b
Double-click the Start Here OSX icon. Follow
the on-screen instructions.
c
Follow the on-screen instructions until this
screen appears. Choose your machine from
the list, and then click OK.
d
When this screen appears, click Next.
IMPORTANT
For Mac OS X 10.4.10 users, upgrade to
Mac OS X 10.4.11 - 10.6.x. (For the latest
drivers and information on the Mac OS X you
are using, visit http://solutions.brother.com/.)
Note
If you want to setup the PS driver (BR-Script3
printer driver), please go to the Brother Solutions
Center at http://solutions.brother.com/ and click
Downloads on your model page to download the
driver and visit FAQ's for installation instructions.
Note
It may take a few minutes for installation to
complete.
Note
• If there is more than one of the same model
connected on your network, the MAC Address
(Ethernet Address) will be displayed after the
model name.
• You can find your machine’s MAC Address
(Ethernet Address) and IP Address by printing
out the Printer Settings Page. See Print the
Printer Settings Page on page 25.
Note
When the Brother Support screen appears,
make your selection and follow the on-screen
instructions.