Brother CS 80 - Manual (Page 28)

GETTING READY ————————————————————————————————————————————————————————
22
c
Pull the thread under the disc at the front in
the lower-left corner and around to the right,
and then cut the thread with the cutter.
Follow arrow 6 indicated on the thread
cassette.
1 Disc
2 Cutter
X The spool of thread is now loaded in the
thread cassette.
Note
● Be sure to cut the thread as described
above, otherwise the needle threader
cannot be used to thread the needle.
Threading the needle
In this section, the procedures for installing the
thread cassette and threading the needle are
described. The needle threader is used to thread the
needle at the same time that the thread cassette is
inserted.
Memo
● The needle threader can be used with
sewing machine needles 75/11 through
100/16.
● Thread with a thickness of 130/20 or less
cannot be used with the needle threader.
● The needle threader cannot be used with
the wing needle or the twin needle.
● If the needle threader cannot be used, refer
to “ Threading the needle manually”
(page 25).
1
Check that the thread cassette indicator is lit
up in green.
1 Thread cassette indicator
If the thread cassette indicator is lit up in red,
the needle has not been raised to the correct
position. Press (needle position button)
once to raise the needle.
1 Needle position button
1
2
1
1
S2_brotherE.book Page 22 Thursday, February 13, 2003 11:03 AM