Brother PT-9600 - Manual (Page 86)

72
ERROR MESSAGE LIST
CHARGE BATTERIES! ● This message appears when the
rechargeable Ni-MH battery has
reached a low voltage. ● Recharge the battery or
use the AC adaptor.
CLOSE CASSETTE
COVER! ● This message appears if the tape
compartment cover is open. ● Close the compartment
cover.
CUTTER ERROR! ● This message appears if the cut-
ter did not operate correctly. ● Turn off the P-touch, and
then turn the P-touch on
again.
● If the problem cannot be
corrected, contact your
service representative.
EEPROM ERROR! ● This message appears if a
checksum error occurred when
the P-touch was turned on or if
the keyword was damaged and
failed to initialize. ● Contact your service rep-
resentative.
FEED ERROR! ● This message appears if the AV
label sensor cannot detect the
labels. ● Replace the AV label cas-
sette with one that is not
empty.
● If this error message
appears even after a new
AV label cassette is
installed, the sensor may
be damaged. Contact your
service representative.
INPUT WHOLE CODE! ● This message appears if the set
number of digits is not entered
in the barcode data. ● Input the correct number
of digits or change the
number of digits set in the
barcode parameters.
INVALID CHARACTERS! ● This message appears if a time
stamp or user-defined character
image is selected when you try
to use the Numbering function. ● Select text or a barcode
before trying to use the
Numbering function.
LENGTH LIMIT! ● This message appears if you try
to print or use the Layout Pre-
view function when the length
of the text is greater than the 3'
1/3" (1 m) limit. ● Delete some of the text.
ERROR MESSAGE CAUSE SOLUTION