ATI Technologies X1950 PRO - Manual (Page 29)

Troubleshooting 23
CrossFire ™ -Specific Troubleshooting
Problem Possible Solution
CrossFire ™ is Not
Functioning
In order for CrossFire ™ to function, the CrossFire ™ Bridge
Interconnects must correctly connect the CrossFire ™
graphics cards.
1. Connect one end of the CrossFire ™ Bridge
Interconnect to the internal VMO connection on one of
the cards.
2. Connect the other end of the CrossFire ™ Bridge
Interconnect to the corresponding internal VMO
connection of the other card.
3. Repeat Steps 1 and 2 to connect the second
CrossFire ™ Bridge Interconnect.
4. Connect the DVI-I connector to your monitor.
“Before
CrossFire ™ can
be enabled, you
need to close the
3D application or
video playback
that is currently
running.”
You cannot enable CrossFire ™ in the Catalyst ™ Control
Center if a 3D application, game, or video playback, such
as a DVD movie, is running.
Close all open 3D applications, games, and movie player
applications then enable CrossFire ™ .
CrossFire ™
Aspect in
Catalyst ™ Control
Center is Not
Displayed
Ensure the CrossFire ™ Bridge Interconnects have been
correctly attached. The CrossFire ™ aspect is only
available when the two Radeon ® X1950 Pro graphics
cards have been correctly installed and connected
together.
“CrossFire ™ Is
Currently
Unavailable.”
This error occurred because CrossFire ™ did not correctly
detect your graphics hardware or there is a problem with
the software.
•
Check the graphics cards are installed correctly.
• Check the interconnects are installed correctly.
• Close all running 3D applications.
• Re-install the Catalyst ™ Control Center.
For information on installing the software see the Getting
Started Guide that came with your graphics card.