Brother MFC 8220 - Manual (Page 96)

SETUP SEND 6 - 7
Manual and automatic fax Redial
If you are sending a fax manually and the line is busy, press
Redial/Pause , and then press Start to try again. If you want to
make a second call to the last number dialed, you can save time by
pressing
Redial/Pause and Start .
Redial/Pause only works if you dialed from the control panel.
If you are sending a fax automatically and the line is busy, the MFC
will automatically redial one time after five minutes.
Dual Access
You can dial a number, and begin scanning the fax into memory—
even when the MFC is receiving, sending or printing a fax from
memory. The LCD shows the new job number.
1
If it is not illuminated in green, press ( Fax ). Load the
original document.
2
Enter the fax number.
3
Press Start to send the fax.
The MFC starts scanning the first page and the LCD shows the
job number (#XXX) of the fax. You can repeat Steps 1 to 3 for
the next fax.
If you get an Out of Memory message while scanning the
first page of a fax, press Stop/Exit to cancel scanning. If you
get an Out of Memory message while scanning a
subsequent page, you can press Start to send the pages
scanned so far, or press Stop/Exit to cancel the operation.