Brother DCP-130C - Manual (Page 73)

60
e
Each color has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f
Lift each lock release lever and push it
until it clicks, and then close the ink
cartridge cover.
g
If you replaced an ink cartridge while the
LCD showed Near Empty, the LCD
may ask you to verify that it was a brand
new one. (For example,
Did You Change Blck?
) For each
new cartridge you installed, press a
(Yes) to automatically reset the ink dot
counter for that color. If the ink cartridge
you installed is not a brand new one, be
sure to press b (No).
If you wait until the LCD shows
Ink Empty
, the machine will
automatically reset the ink dot counter.
Note
If the LCD shows Install after you
install the ink cartridges, check that the ink
cartridges are installed properly.
WARNING
If ink gets in your eyes, wash them out with
water at once and call a doctor if you are
concerned.
CAUTION
DO NOT take out ink cartridges if you do
not need to replace them. If you do so, it
may reduce the ink quantity and the
machine will not know the quantity of ink left
in the cartridge.
DO NOT touch the cartridge insertion slots.
If you do so, the ink may stain your skin.
If ink stains your skin or clothing, wash with
soap or detergent at once.
If you mix the colors by installing an ink
cartridge in the wrong position, clean the
print head several times after correcting the
cartridge installation.
Once you open an ink cartridge, install it in
the machine and use it up within six months
of installation. Use unopened ink cartridges
by the expiration date written on the
cartridge package.
DO NOT dismantle or tamper with the ink
cartridge; this can cause the ink to leak out
of the cartridge.
M
brother
XXXX