Auto Page Professional Vehicle Security System RF-420LCD - Manual (Page 8)

8
PROGRAM MODE FOR LCD REMOTE CONTROL TRANSCEIVER:
Trans ceiv er Button
System Function Remark
Program Mode -
Switching code for 2nd / 1st Car Operation Press within 5 seconds
Program Mode -
Melody / Vibration Mode Press within 5 seconds
Program Mode -
Power Save Mode Press within 5 seconds
LCD screen lamp turns on for 5 seconds.
- +
System’s Status Check Press within 3 seconds
- +
Clear the Flash Icon and Melody Sound Press within 3 seconds
1. Second Vehicle Security Operation: Your remote transmitter can be utilized to control a
second vehicle Autopage security system . To program the remote control transmitter to a
second vehicle, follow the instructions for Transmitter programming. Al l programming
parameters are the same except for the following:
For Regular Remote Control Transmitter :
1. Prior to pushing any button on the transmitter. Press the Select II button first on the standard
transmitter.
2. Once II button is pressed the LED on the transmitter will illuminate for 3.5 seconds . While the
LED is illuminated, press the button for the function you want to operate on the standard
remote transmitter to control a second vehicle security system .
For 2-way LCD Remote Control Transceiver:
2nd
Car Operation: While the “II” icon display on the LCD screen, you can remote control and
communicate with a second Autopage AM frequency security system. It has two short “beep”
sounds while pressing the
button of the LCD screen transceiver
1. Press and hold all four remote control buttons simultaneously unit one long
beep is heard. LCD Programming has now been entered.
2. Within 5 seconds press and hold button until two beeping sounds is
heard and the “II” icon will display on the LCD screen to indicate the second
transceiver pin code has built-in.
3. To exit programming mode, take no action for five seconds. The remote
control will generate two long beeps to indicate programming mode has
been exited.
Back to First Car Operation:
You can remote control and communicate with a first vehicle security system. It has one short
“beep” sound while pressing the button of the LCD screen transceiver.
1. Press and hold all four remote control buttons simultaneously unit one long
beep is heard. Programming has now been entered.
2. Within 5 seconds press and hold button until one beeping sound is heard.
3. To exit programming mode, take no action for five seconds. The remote
control will generate two long beeps to indicate programming mode has been
exited.
Vibration / Melody Mode:
Vibration mode is useful when you are in a noisy place and it is difficult to hear beep sound from
the remote control. In this mode the remote control will vibrate if your security system is
triggered.
1. Press and hold all four remot e control buttons simultaneously unit one long
beep is heard. Programming has now been entered.
2. Within 5 seconds, press the button to select the mode of vibration or melody,
the icon will displayed on the LCD screen to show the LCD remote
transceiver is on vibration mode.
3. To exit programming mode, take no action for five seconds. The remote control
will generate two long beeps to indicate programming mode has been exited.